3d printing water level adjustors for im 30L

[Nem0]

looking to raise the water level on my IM 30. I found these - https://ez-dose.com/product/ez-water-level-adjuster-full-set-midsize/

cost is $15 which i would be okay with but shipping for another $15? i wouldn't condone spending $30 for 2 pieces of plastic lol...does anyone 3d print these?

 

[That Crusso Kid]

looking to raise the water level on my IM 30. I found these - https://ez-dose.com/product/ez-water-level-adjuster-full-set-midsize/

cost is $15 which i would be okay with but shipping for another $15? i wouldn't condone spending $30 for 2 pieces of plastic lol...does anyone 3d print these?

I'm not sure if anyone prints those but if you try posing your question here, you may get some replies;

https://www.reef2reef.com/threads/3d-printed-builds-lets-inspire-others.544969/page-16

Also, @dantimdad might be able to assist.

 

[reefwiser]

What is the reason you want to raise the water level in the tank. When you do this it will change the water level in the rear and you will have to add water there. You then get in a situation where you could have a flood if the weir gets blocked for any reason.

 

[Nem0]

I'm not sure if anyone prints those but if you try posing your question here, you may get some replies;

https://www.reef2reef.com/threads/3d-printed-builds-lets-inspire-others.544969/page-16

Also, @dantimdad might be able to assist.

i actually made a mistake. the shipping was free lol. i ended up just buying it!

 

[Nem0]

What is the reason you want to raise the water level in the tank. When you do this it will change the water level in the rear and you will have to add water there. You then get in a situation where you could have a flood if the weir gets blocked for any reason.

well with the tank has like a 2in difference between the max water level and the top of the glass. 1-for aesthetic reasons 2- i can fit prob 1.5+ more gallons of water in the tank if I raise it an inch or so. more water is never a bad thing. i've done my share of research and have seen people raising the water level successfully, whether its using a 3d printed part or simply silicioning some plastic or acrylic on the back of the overflow gates.

 

[reefwiser]

I have the 40 gallon of this tank. I would not do it. But what do I know I have only been keeping fish for 55 years. [emoji3]