500g+ build planning questions

Biff0rz

Valuable Member
View Badges
Joined
Jul 9, 2020
Messages
2,401
Reaction score
1,442
Location
Michigan (SE)
Rating - 100%
2   0   0
I'm planning a 10', 505g or 560g tank, I have a couple of the big boy questions....

humidity - I was considering buying a Sante Fe Ultra98 (100p/day) dehumidifier and routing ducting above the tank and sump room, then draining out the sewer. Will this be sufficient or should I take more precautionary measures? This will be in a finished basement (2k sqft) with lots of wood and it's fully finished. Do I/should I do any sort of vapor barrier installation?

Heating - I currently use an inkbird control with multiple heaters. I've read good things about using the heat from my water heater as an option. Is this necessary for a tank this size? I'm in Michigan, temps get cold cold, but the basement is temp controlled and rarely goes below 68* nor above 72*. I currently have a 230g system that stays stable at 78*.
 
Following along!
 
I have an exhaust fan I’m my tank room. Continuous duty. It also has an A/C and Heater duct as part of the whole house system. The tank, 500g does put off some humidity. We have a very open floor plan so it’s not a problem. I did paint the walls in the tank room with a gloss paint , just in case. Anything you can do before the tank is set up , the better.
Heaters. I have 2ea 300w titanium heaters. Each with its own controller. Backed up with my Apex. Prob over kill.
 
Well, I guess I started. Purchased the Santa Fe dehumidifier today since my portable died, found a deal on a brand new Reef Octo 300EXT for $700 and picked that up, and then finalizing tank designs and logistics soon.

120x36x30
low-iron on front, sides, euro bracing
armored seals
2x 2400gph modular marine overflows on either end
4 return bulkheads in the middle with lineloc/RFG's for flow in the middle

Still considering a closed loop on the bottom - i've heard so many pro's/con's to both, sigh.

big glass box picture-
1784838154655.png


Stand is being spec'd but I'm going to go with a similar design to this where pull out stands are built into the bottom along with wood facade with magnets (thomas coral design)

1784838154669.png
 

TOP 10 Trending Threads

WHAT PART OF LIVING WITH A REEF TOOK YOU BY SURPRISE?

  • How much space the supplies and equipment take up

    Votes: 9 56.3%
  • Salt creep, spills, and cleanup outside the tank

    Votes: 2 12.5%
  • Planning trips or finding someone to care for the reef

    Votes: 5 31.3%
  • How attached I’d get to individual animals

    Votes: 2 12.5%
  • Making decisions when there’s no clear right answer

    Votes: 3 18.8%
  • How much the reef affects everyday household life

    Votes: 5 31.3%
  • Nothing in particular, I felt well prepared

    Votes: 0 0.0%
  • Other (Post in the comments)

    Votes: 1 6.3%
Back
Top
Home
Post thread…
Market
What's new