9012dc question

  • Thread starter Thread starter reely989
  • Start date Start date
  • Tagged users Tagged users None

reely989

Active Member
View Badges
Joined
Nov 1, 2022
Messages
345
Reaction score
234
Location
Auburn
What state or country do you live in
Alabama
Rating - 0%
0   0   0
I have the 9012 dc and am having micro bubbles after a lot of tweaking. I want to try raising it a little more but I have a rimmed tank. Is there an easy way to get it raised higher? The trim blocks the magnets
 
I can’t help with the question, but I can bump the thread to see if we can get you some assistance
 
I have the 9012 dc and am having micro bubbles after a lot of tweaking. I want to try raising it a little more but I have a rimmed tank. Is there an easy way to get it raised higher? The trim blocks the magnets
Not sure if you found a way. But I cut pcv of the height I wanted to raise mine and drilled big holes in it and have them in the bottom of my 2nd return compartment. Doesn't restrict the flow or have a dead spot and raised mine above the recommended water line of the skimmer and produced a much drier denser foam. I have a cheap $80 magtool. But with the design of the body and the DC motor w speed dial it's super easy to dial in. Plenty on a 15 that only holds 12g after sand and rock.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new