AIO Backwall "design" question

[PapoReef]

Hey Guys! Long time since I last posted. I'm custom building a new AIO aquarium, and I will be lasercutting the back wall. I will have the design made by the cutters, but I need to tell them how high and how tick and how apart should the "comb" of the backwall be. I will make it like the Nuvo 20, with one comb on each side of the back wall. Please help as its the first time I'm having a AIO made and I want to get it right the first time. Thanks a lot!!

 

[Timfish]

Decide where you want your water line. Have the "comb" or weir cut so they start about 1/4" below the anticipated water line.

 

[srobertb]

Hey Guys! Long time since I last posted. I'm custom building a new AIO aquarium, and I will be lasercutting the back wall. I will have the design made by the cutters, but I need to tell them how high and how tick and how apart should the "comb" of the backwall be. I will make it like the Nuvo 20, with one comb on each side of the back wall. Please help as it’s the first time I'm having a AIO made and I want to get it right the first time. Thanks a lot!!

If I was home, Id measure then tell you not to use those measurements. I have an IM10, 20, and used to have the 40. The overflow walls constantly clogged for the first 1-2 years of the tanks life. I actually had an anemone perfectly flatten its tentacles on the weir and screw everything up. I have a high sensor in those tanks now for that reason.

 

[PapoReef]

Thanks for the tips guys!