Algae Scrubber Output Plumbing?

  • Thread starter Thread starter AquAttila
  • Start date Start date
  • Tagged users Tagged users None

AquAttila

Active Member
View Badges
Joined
Jun 9, 2018
Messages
324
Reaction score
163
What state or country do you live in
New Jersey
Rating - 0%
0   0   0
I have a question as I am concerned that I should have plumbed by output of my clearwater algae scrubber into my skimmer input. Is this the recommended method? I am asking because right now I have the output of the scrubber right into the sump - what I noticed is that if I don't clean the scrubber in time, the algae of course ends up in my sump and then the strainer don't catch all of the algae and end up in my tank. Any recommendations is appreciated! I do recall reading some place (probably on R2R) that some do plumb output of the scrubber to the input of the skimmer.

Thanks!
 
The output of mine enter the sump prior to my mechanical filtration which in turn can catch any runaway algae. You could always put a coarse foam in a bubble trap or maybe have the output of your ATS go into a sock. I am not sure if I would completely rely on the skimmer as some bit of algae might be too big to get captured by the skimmer.
 
appreciate the quick response! yeah, I was thinking of the filter sock idea. I was thinking the skimmer as the output of the skimmer goes into a sock and would catch any algae that way. I may go with your idea and just put a filter sock on the output of the ATS for now and see how that works out... easier then plumbing anyways.
 
Mine drains into my sump Prior to the skimmer. I didn’t want to create a bunch of complicated pluming. I have a filter sock tied to the output
 
Ours dumps into the same chamber that the skimmer sits in. The one time I have cleaned out the scrubber chamber (while still in place) I had a little algae escape, but othet than that, I haven't ever really noticed any algae escaping the scrubber. I clean the screen once a week.........well.......usually. We do not have any algae growing in the tank (and we started with a neglected tank that had furry algae covered rocks that were flowing like a torch). I'm glad the algae is gone, but I almost feel kinda sorry for the algae eaters that we have! If some algae from the scrubber made it's way to the tank today, I wouldn't really care. It's not going to to grow in there!
 
Just be mindful that you don’t want the output to get blocked in any way. I always put an emergency drain into mine ..... just in case.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new