ok, well I'm still struggling with setting up my Apex, this time with my heater and to be more specific; the Hysteresis setting so the heater doesn't constantly cycle on and off based in small variations of the temp. On my old controller, I set the Hysteresis to 1 degree.
so looking in the manual I see on page 62 the concept of Hysteresis is discussed
Here's where I'm confused. I log into http://apex.local/ and select the outlet the heater is plugged into on the power bar. I go to the drop down menu labeled Control Type and select heater. this changes the configuration window on the right and I can enter a on and off temp range. This all makes sense to me!
Where I'm stumped is I can't figure out how to enter a Hysteresis of 1 degree in this configuration window?
Thanks all for the help, I'm sure this is a super simple question!
so looking in the manual I see on page 62 the concept of Hysteresis is discussed
Here's where I'm confused. I log into http://apex.local/ and select the outlet the heater is plugged into on the power bar. I go to the drop down menu labeled Control Type and select heater. this changes the configuration window on the right and I can enter a on and off temp range. This all makes sense to me!
Where I'm stumped is I can't figure out how to enter a Hysteresis of 1 degree in this configuration window?
Thanks all for the help, I'm sure this is a super simple question!