Apex atk if command with time

[Mr. GoodStuff]

Fallback OFF
Set OFF
If ATK_LO OPEN Then ON
If ATK_HI CLOSED Then OFF
If ATO_LO OPEN Then OFF
When On > 001:30 Then OFF
Defer 000:20 Then ON
Defer 000:10 Then OFF
Min Time 060:00 Then OFF

So that’s my current ATK lines. Is it possible to set the ATK_HI portion with time? So it only activates that line after a set amount of time, like if ATK_HI is CLOSED for more than 10 seconds then it will turn OFF instead of immediately?

If ATK_HI CLOSED > 000:020 Then OFF

Is that a thing? My issue is the optical sensors are right below the float valve so when it fills the water basically runs down onto the optical sensors and sometimes triggers the ATK_HI sensor. If not possible I guess I can probably readjust some things.

 

[Jason_MrFrags]

You can take the ATK_HI and create a virtual outlet, then use the virtual outlet in this programing.

 

[Mr. GoodStuff]

You can take the ATK_HI and create a virtual outlet, then use the virtual outlet in this programing.

but what 60 Min time. So its going to run for 60 minutes once tripped regardless.

Yea I ended up moving the float valve a little bit so it doesn’t dump water right on top of the sensor.