- Joined
- Dec 29, 2019
- Messages
- 438
- Reaction score
- 595
I've had it up and running for 6+ months now. However, twice now the ATO has switched itself from auto to OFF in that 6 month time period. Luckily i've been home when this happens and can hear the increased noise level from the water level dropping in the sump. I should also note, each time the sump low water sensor read OPEN when it shut itself off so it isn't a dirty sensor. I clean them every week.
My code:
Fallback OFF
Set OFF
If ATK_H OPEN Then ON
If ATK_L CLOSED Then OFF
If ROLow OPEN Then OFF
When On > 005:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 120:00 Then OFF
The last time it happened. I stood by my reservoir and kicked it on manually. The pump turned on for about 5 seconds then shut off. Took the pump out. It looked fine. Put it back in turned it back on and it worked just fine. Maybe it sucked in air some how? My Reservoir is 55 gallons and I always fill it back up when it gets to the halfway point so it never even comes close to running dry.
Just wondering if any long term users have run into it shutting itself off from auto mode.
My code:
Fallback OFF
Set OFF
If ATK_H OPEN Then ON
If ATK_L CLOSED Then OFF
If ROLow OPEN Then OFF
When On > 005:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 120:00 Then OFF
The last time it happened. I stood by my reservoir and kicked it on manually. The pump turned on for about 5 seconds then shut off. Took the pump out. It looked fine. Put it back in turned it back on and it worked just fine. Maybe it sucked in air some how? My Reservoir is 55 gallons and I always fill it back up when it gets to the halfway point so it never even comes close to running dry.
Just wondering if any long term users have run into it shutting itself off from auto mode.