Apex Jr question...return pump/feed mode and ATO

  • Thread starter Thread starter Hipertec
  • Start date Start date
  • Tagged users Tagged users None

Hipertec

Community Member
View Badges
Joined
Aug 1, 2016
Messages
73
Reaction score
10
Rating - 0%
0   0   0
I just picked up an Apex Jr controller with 4 outlets and hooked up to ethernet. I have outlets programmed for:
1 return pump
2 heater
3. Moonlight (my led has builtin timer)
4. Fan

I really like the feed mode where I want to shut off the return pump so food does not go down my sump.

My issue is that I have an Tunze 3599 auto topoff with the safety backup switch which buzzes and shuts off ATO when the level is too high (ie when return pump stops)

How are you guys getting by this with limited outlets? My thought was to piggyback on the return pump outlet with the ATO plug so when the return pump is off, the ATO shuts off too. With this method, the buzzer sound will go on for about 30seconds when the outlet turns back on since the level is still high.

Any other thoughts or options?
 
I just picked up an Apex Jr controller with 4 outlets and hooked up to ethernet. I have outlets programmed for:
1 return pump
2 heater
3. Moonlight (my led has builtin timer)
4. Fan

I really like the feed mode where I want to shut off the return pump so food does not go down my sump.

My issue is that I have an Tunze 3599 auto topoff with the safety backup switch which buzzes and shuts off ATO when the level is too high (ie when return pump stops)

How are you guys getting by this with limited outlets? My thought was to piggyback on the return pump outlet with the ATO plug so when the return pump is off, the ATO shuts off too. With this method, the buzzer sound will go on for about 30seconds when the outlet turns back on since the level is still high.

Any other thoughts or options?
an

Can you add an EB8 bar? That’s what I did with my Apex Jr. If not, could you just unplug the ato during feedings? Or turn off the alarm?
 
If you have a timer for the moon light I would just use that on a conventional power strip. Then you could use one of the Apex outlets for the ATO and set the delay to come on a few minutes after the return pump comes back on.
 

WHAT KIND OF SUBSTRATE ARE YOU RUNNING ON YOUR TANK?

  • Bare bottom

    Votes: 6 20.7%
  • A shallow bed of fine sand

    Votes: 8 27.6%
  • A shallow bed of coarser sand

    Votes: 6 20.7%
  • A deep sand bed

    Votes: 3 10.3%
  • Mixed substrate or varying sand depth

    Votes: 6 20.7%
  • Some other substrate (posted in the comments)

    Votes: 0 0.0%
  • I don’t have a reef tank yet

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new