Apex Jr question...return pump/feed mode and ATO

Hipertec

Community Member
View Badges
Joined
Aug 1, 2016
Messages
73
Reaction score
10
Rating - 0%
0   0   0
I just picked up an Apex Jr controller with 4 outlets and hooked up to ethernet. I have outlets programmed for:
1 return pump
2 heater
3. Moonlight (my led has builtin timer)
4. Fan

I really like the feed mode where I want to shut off the return pump so food does not go down my sump.

My issue is that I have an Tunze 3599 auto topoff with the safety backup switch which buzzes and shuts off ATO when the level is too high (ie when return pump stops)

How are you guys getting by this with limited outlets? My thought was to piggyback on the return pump outlet with the ATO plug so when the return pump is off, the ATO shuts off too. With this method, the buzzer sound will go on for about 30seconds when the outlet turns back on since the level is still high.

Any other thoughts or options?
 

glb

7500 Club Member
View Badges
Joined
May 12, 2013
Messages
8,185
Reaction score
3,301
Location
Miami
Rating - 0%
0   0   0
I just picked up an Apex Jr controller with 4 outlets and hooked up to ethernet. I have outlets programmed for:
1 return pump
2 heater
3. Moonlight (my led has builtin timer)
4. Fan

I really like the feed mode where I want to shut off the return pump so food does not go down my sump.

My issue is that I have an Tunze 3599 auto topoff with the safety backup switch which buzzes and shuts off ATO when the level is too high (ie when return pump stops)

How are you guys getting by this with limited outlets? My thought was to piggyback on the return pump outlet with the ATO plug so when the return pump is off, the ATO shuts off too. With this method, the buzzer sound will go on for about 30seconds when the outlet turns back on since the level is still high.

Any other thoughts or options?
an

Can you add an EB8 bar? That’s what I did with my Apex Jr. If not, could you just unplug the ato during feedings? Or turn off the alarm?
 

new2reefin

Community Member
View Badges
Joined
Aug 9, 2017
Messages
90
Reaction score
20
Rating - 0%
0   0   0
If you have a timer for the moon light I would just use that on a conventional power strip. Then you could use one of the Apex outlets for the ATO and set the delay to come on a few minutes after the return pump comes back on.
 

TOP 10 Trending Threads

WHAT AMOUNT OF LIVE ROCK AND SAND SHOULD BE PRIORITIZED FOR OPTIMAL BIODIVERSITY/FILTRATION?

  • 100% live rock + bagged sand

    Votes: 38 26.6%
  • 100% dry rock + 100% live sand

    Votes: 48 33.6%
  • 50/50 live/dry rock, 50/50 live/bagged sand

    Votes: 32 22.4%
  • 75% live rock, 25% live sand

    Votes: 15 10.5%
  • 25% live rock, 75% live sand

    Votes: 10 7.0%
Back
Top