Newbie Q here. I am running my heater through a controller which is connected to an EB832. I'm letting the controller manage the temp, and having the Apex act as a backstop which will turn the heater off if it gets too warm. My question is on the "Fallback" command. Right now I'm using the following lines
Fallback OFF
Set ON
But my understanding is that "Fallback" is the default if the EB832 isn't communicating with the Apex Controller. Since I have a controller managing the heater, should this be "Fallback ON"?
Thanks in advance.
Fallback OFF
Set ON
But my understanding is that "Fallback" is the default if the EB832 isn't communicating with the Apex Controller. Since I have a controller managing the heater, should this be "Fallback ON"?
Thanks in advance.