Good evening,
Just finished up installing the final ATK RO_LO sensor into my Synergy Reef ATO. Really cool setup but a couple of questions on the FMM.
With the settings on AUTO for the FMM it shows to be "off" and not "auto" --> normal??
The third optical sensor is showing open instead of closed when it is sitting in 9 gallons of water --> It should be closed when full of water correct? Any suggestions to fix?
If someone can verify this code so I do not burn up the pmup that would be great!!!
Fallback OFF
Set OFF
If ATK_LO OPEN Then ON
If ATK_HI CLOSED Then OFF
If RO_LO OPEN Then OFF
If Output Maintenance = ON Then OFF
When On > 003:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 030:00 Then OFF
Also, I just became a R2R supporter and wasn't sure when that will display on my account?
Just finished up installing the final ATK RO_LO sensor into my Synergy Reef ATO. Really cool setup but a couple of questions on the FMM.
With the settings on AUTO for the FMM it shows to be "off" and not "auto" --> normal??
The third optical sensor is showing open instead of closed when it is sitting in 9 gallons of water --> It should be closed when full of water correct? Any suggestions to fix?
If someone can verify this code so I do not burn up the pmup that would be great!!!
Fallback OFF
Set OFF
If ATK_LO OPEN Then ON
If ATK_HI CLOSED Then OFF
If RO_LO OPEN Then OFF
If Output Maintenance = ON Then OFF
When On > 003:00 Then OFF
Defer 000:10 Then ON
Defer 000:04 Then OFF
Min Time 030:00 Then OFF
Also, I just became a R2R supporter and wasn't sure when that will display on my account?