I recently picked up a used Apex classic. I added a break-out box, (diy) and two float switches in ports one and two. I am struggling to get the ATO function to work properly. Any advice is welcome. I verified the pin out of the break out box with a VOM and a diagram of the connector found on an older thread. The pumpis on outlet 3. It turns on but then keeps going after the high level switch should kick it off.
Fallback OFF
Set OFF
If Sw1 OPEN Then ON
If Sw2 CLOSED Then OFF
Defer 001:00 Then ON
oddly, i also have this error every hour
Fallback OFF
Set OFF
If Sw1 OPEN Then ON
If Sw2 CLOSED Then OFF
Defer 001:00 Then ON
oddly, i also have this error every hour