Autoaqua Smart ATO users beware

  • Thread starter Thread starter DirtMcGurt
  • Start date Start date
  • Tagged users Tagged users None

DirtMcGurt

Well-Known Member
View Badges
Joined
May 17, 2018
Messages
718
Reaction score
361
What state or country do you live in
Alabama
Rating - 0%
0   0   0
I've had some issues with my diy ato so I attempted to use an Autoaqua Smart ATO that I bought used from the dry goods forum on here. Well... I couldn't get it to initialize and though it might be because the clear section of the wet side had scratches. So in an attempt to remove it I found the inside magnet was very rusted. You know what that means... if saltwater gets in to rust the magnet then the rust gets out into your tank.

20191001_091333.jpg
 
This may or may not be the fault of the manufacturer. If you've seen the thread on Vinegar the Pump Killer, it could be the use of vinegar to clean the wet side. However, the plastic ring popped off fairly easily so I'm not sure how well those things are sealed. Just a heads up to people with this ATO.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new