Automatic water change question.

  • Thread starter Thread starter Toddah
  • Start date Start date
  • Tagged users Tagged users None

Toddah

Community Member
View Badges
Joined
Dec 15, 2007
Messages
69
Reaction score
64
Rating - 0%
0   0   0
I have a dual diaphragm industrial pump I have used for years on my past aquariums and I have set it up to do automatic water changes on my 40 Nuvo AIO. My question is what is the best way to schedule the system to do said water changes.
The pump is capable of moving 6.5 GPD but can be adjusted down to 1 GPD. It's a geardrive pump and sounds like a rotisserie motor when running throttled back but wide open is 1/4 as loud.
I can run it wide open and control the lenght of time it runs using my APEX with some overwatch by float switches to be sure its not uver or under filling.
OR
I can just throttle it back and leave it run 24 x 7 for a continuous water change as I had it setup before.
Is there an advantage to the tank or inhabitants of doing it one way or another?
 
I have mine set to run once a day because its relatively loud. I think anyway you decide to do it is fine and you won't see any difference in the tank
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 17.7%
  • Fish or coral food

    Votes: 5 5.2%
  • Test kits or reagents

    Votes: 10 10.4%
  • Filter media or replacement fleece

    Votes: 5 5.2%
  • RO/DI filters or supplies

    Votes: 15 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 12 12.5%
  • I keep a backup of everything

    Votes: 25 26.0%
  • Other (Post in the comments)

    Votes: 7 7.3%
Back
Top
Home
Post thread…
Market
What's new