Hello,
I have just set up my DOS for Manual Waterchange, i have calibrated my DOS and that went ok, I went through the tasks function for manual water change and enter all the info it wanted, set it to Feed D cycle. Then it says, if you would like to do this water change now, hit Feed, so I did; and nothing happens. So I went to my dashboard and hit feed D myself and still nothing happens. My DOS is set to ON for the power, and. DOS_ADD and DOS_REMOVE are set to Auto and it says TBL above the “on”
Please help.
I have just set up my DOS for Manual Waterchange, i have calibrated my DOS and that went ok, I went through the tasks function for manual water change and enter all the info it wanted, set it to Feed D cycle. Then it says, if you would like to do this water change now, hit Feed, so I did; and nothing happens. So I went to my dashboard and hit feed D myself and still nothing happens. My DOS is set to ON for the power, and. DOS_ADD and DOS_REMOVE are set to Auto and it says TBL above the “on”
Please help.