Right. I'll just have to wire an external connector to the connector on the Tentacle board. Should be easy enough cut one end off of a short cable and solder it to the inside of a panel mount connector. I have the connectors, and am planning for future expandability.
Back into the hobby - 29G Biocube Plan and Build (Long and Drawn Out)
Right. I'll just have to wire an external connector to the connector on the Tentacle board. Should be easy enough cut one end off of a short cable and solder it to the inside of a panel mount connector. I have the connectors, and am planning for future expandability.
Designing for 3D printing certainly has a learning curve.
Issues that I have run into:
Hopefully, this is the last design before proper printing.
Issues that I have run into:
- I made the text too small, so it didn't bond properly.
- I then made it larger but ran into clearance issues w/ mounting the jacks.
Hopefully, this is the last design before proper printing.
looking goodDesigning for 3D printing certainly has a learning curve.
Issues that I have run into:
So I made a few changes. I've switched from labeling the jacks with their names I went with numbering them. There are 10 jacks, so #10 is labeled "X" both for symmetry as well as clearance. "10" did not clear properly between the holes.
- I made the text too small, so it didn't bond properly.
- I then made it larger but ran into clearance issues w/ mounting the jacks.
Hopefully, this is the last design before proper printing.
Similar threads
