Best Way to Clear Dosing Lines

[Sdoutreefer]

I’m new to having automated dosing pumps and am wondering what the best way to clear the line is? I’m switching from AFR to BRS 2-part + Mag. Pump is the DOSqd, if that matters

Any feedback/advice is appreciated!

 

[braaap]

Hot water and a syringe. Or just hot water and use the pump to move fluid through the lines.

 

[Sdoutreefer]

Hot water and a syringe. Or just hot water and use the pump to move fluid through the lines.

Ok, that’s simple. Maybe I’m overthinking it. So basically pull the line from the sump area, and run it to a cup to collect the liquid. Then push air through the lines… got it.

Silly question now that I’m reading the steps I spelled out to myself…

 

[RedReefer]

Install new lines. They are cheap…

 

[maroun.c]

They clog up at the output normally so maybe just place the output in a vinegar cup for few minutes hours ... or u can push some vinegar through them and discard the output then rinse by pushing enough Ro water through them

 

[Sdoutreefer]

Install new lines. They are cheap…

Good idea.