Burning rubber/plastic

thatone08

Valuable Member
View Badges
Joined
May 16, 2021
Messages
1,216
Reaction score
6,190
Location
plainfield
Rating - 0%
0   0   0
Forgive me if this is a dumb question, but I’m having a day.

While feeding my scorpion I didn’t move the heat lamp far enough from the edge. Which then proceeded to melt the plastic/ rubber of the lip the lid slides into. This caused a burning plastic/rubber smell to then fill the room.

Just happens to be where my waterbox 90.3 I’m setting up is. As well as all my dry rock. That I had laid out to start scaping. Once I took care of how it was burning I then proceeded to cover up the rock. And bring down my air purifier.

Is it possible for the smell to affect the rock? Or am I ok since none the burning material touched the rock?

Am I just thinking the worst because of the day I’m having?
 
To be safe you can do a 20 percent water change and add carbon. I think you be ok though.
 
Believe it or not teflon pans = death very toxic and to birds I think. Anyway, think you be ok. I would run carbon though safe measure can't hurt.
 
Carbon and water changes is what I would do!
 

HOW MUCH DOES A FISH’S FEEDING REQUIREMENTS AFFECT YOUR STOCKING DECISIONS?

  • A lot! - I avoid fish that require frequent or specialized feeding

    Votes: 7 26.9%
  • Quite a bit, but an automatic feeder can change my answer

    Votes: 5 19.2%
  • It depends on whether my nutrient export can handle it

    Votes: 5 19.2%
  • It depends on how badly I want the fish

    Votes: 8 30.8%
  • Not much. I’m willing to adjust my routine

    Votes: 5 19.2%
  • Not at all. Feeding demands don’t limit my stocking choices

    Votes: 5 19.2%
  • I usually learn about the demanding feeding schedule after buying the fish!

    Votes: 1 3.8%
  • I haven’t really considered this before

    Votes: 2 7.7%
  • Something else (see my comments in the thread)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new