Hey guys.
need some help. I’m trying to fine tune my reactor. Currently my solenoid goes over every10-12 mins. I’m trying to prevent the wear and tear on the apex.
current settings
PSI. 3-4 lbs
32mls - Flow is the kameor. Setup to pull the water through the reactor.
ph is 7.10-7.20
Again it cycles every time 10-12 mins but now sure how to reduce it. If I Lower psi. No bubbles. If I extend the ph range alk fluctuates too much.
Thanks for any advise and stay safe
need some help. I’m trying to fine tune my reactor. Currently my solenoid goes over every10-12 mins. I’m trying to prevent the wear and tear on the apex.
current settings
PSI. 3-4 lbs
32mls - Flow is the kameor. Setup to pull the water through the reactor.
ph is 7.10-7.20
Again it cycles every time 10-12 mins but now sure how to reduce it. If I Lower psi. No bubbles. If I extend the ph range alk fluctuates too much.
Thanks for any advise and stay safe