Calcium Reactor with Kamoe FX-STP2 , pull or push?

[A_Blind_Reefer]

Ai is taking over. Bots have invaded. Skynet is real! Im going to unplug and beef up that faraday cage.

 

[Reefering1]

Ai is taking over. Bots have invaded. Skynet is real! Im going to unplug and beef up that faraday cage.

 

[Sisterlimonpot]

Ai is taking over. Bots have invaded. Skynet is real! Im going to unplug and beef up that faraday cage.

Do you see down at the bottom right of that post? It says, speed test.... what's that all about?

 

[Reefering1]

It's a link, don't click it

 

[A_Blind_Reefer]

Do you see down at the bottom right of that post? It says, speed test.... what's that all about?

I noticed that as well. It’s like the praetorians in “the net” don’t click the pi symbol!

 

[WhatCouldGoWrong71]

Oh poop. I’ve had this wrong all along. dangit. I thought you pushed. I started using a Kamoer when I got my new Geo 1218 SSE. So, I also set this up to push. I have been struggling with keeping calibration. I would set it at 95 mil then a few days later it would be at 60, I would notice as I would start to fall off and my AquaWiz would be heavily compensating with dosing bicarb to keep me on target. Last night a I calibrated again and it said my max output was now 89.5, so not wanting to run it at max, I backed it down to 80 mil and we’ll then that mucked with my PH.

So if I set this up to pull. How long should I wait to recalibrate? I know there is no way that I am going to pull the same rate, it should pull way more. Can I just instantly recalibrate?