Can any explain RS mag test to me

Kingsley_Reef

Valuable Member
View Badges
Joined
Jul 22, 2018
Messages
2,021
Reaction score
5,397
Location
Pennsylvania
Rating - 100%
3   0   0
Having a stupid moment trying to understand how to read the syringe I used this much titrations
B3A55F34-D9EF-4F9C-AEE5-29AAD6A53D12.jpeg
so how do I relay this to these numbers on the card?
D1A202E7-3598-4C37-B8D1-82BF3D3F4683.jpeg
 
Having a stupid moment trying to understand how to read the syringe I used this much titrations
B3A55F34-D9EF-4F9C-AEE5-29AAD6A53D12.jpeg
so how do I relay this to these numbers on the card?
D1A202E7-3598-4C37-B8D1-82BF3D3F4683.jpeg

Looks like .22 or .23. If so, it's very low.

I'd retest for sure.

The bottom seal lip on the rubber stopper is your mark.
 
Well that’s what’s left in the 1ml syringe so I assume you have to read the marks in reverses to calculate tritant used??? So almost using the entire syringe wouldn’t my mag be high?

Yes, what's left in the tip and syringe, where the stopper stops is the reading. It's looks from the picture to be .22 or .23. That's well below the lowest value on the chart.

Seems wrong. Magnesium isn't normally consumed out of saltwater nearly as much as alkalinity or calcium. Assuming your salinity is correct or you stopped when the color change happened.

I'd retest.
 
I’m my understanding I’ve used over 0.7ml of the 1 ml syringe so how do I relate that to the card or am I completely reading the syringe wrong?;Hilarious

Okay, your right. Was thinking of salifert mag kit. It's the amount of tritation fluid used, not what's left.

How much you used is the reading.

Sorry about that. It's one of the reasons I stopped using red Sea magnesium kits and went to salifert.
 
If I'm not mistaken, you measure how much titrant you used, and compare that number to the card? Otherwise I've been doing it wrong

No, your right. It's measured by how much you use. Not what's left. Salifert is so much easier for me.
 
No, your right. It's measured by how much you use. Not what's left. Salifert is so much easier for me.
I use the Salifert nitrate test... coming from Fluval and API. Its unreal how much easier that test is. Is the mag test similar?
 
I just switched from all api to Red Sea cal pro,mag pro,pho’s pro, marine care and trace colors hoping for better accuracy I’m a questionable with the nitrate results the Red Sea always reads high but then the api reads 0
 
It's a common error with Red Sea kits......the syringe, when full is 1 ml. When you are done with the titration, the amount you put into the vial IS NOT THE READING ON THE SYRINGE. You need to take that reading on the syringe and subtract it from 1. So if the syringe says 0.23, the amount you used is 1 - 0.23 = 0.78 mls......which equals 1560.
 
It's a common error with Red Sea kits......the syringe, when full is 1 ml. When you are done with the titration, the amount you put into the vial IS NOT THE READING ON THE SYRINGE. You need to take that reading on the syringe and subtract it from 1. So if the syringe says 0.23, the amount you used is 1 - 0.23 = 0.78 mls......which equals 1560.
Gotcha thanks
 

TOP 10 Trending Threads

WHAT KIND OF REEFING DEAL ARE YOU HOPING TO PICK UP THIS BLACK FRIDAY?

  • A whole new aquarium or complete system

    Votes: 1 7.1%
  • Lighting, pumps, or other major equipment

    Votes: 2 14.3%
  • Controllers, testing, dosing, or automation gear

    Votes: 2 14.3%
  • Dry goods and restocks, like salt, media, or food

    Votes: 1 7.1%
  • Corals! Must...Have...CORALS!!!

    Votes: 3 21.4%
  • Fish or other livestock

    Votes: 0 0.0%
  • Rock, sand, or other aquascaping supplies

    Votes: 1 7.1%
  • I’m browsing, but don’t have a specific target

    Votes: 2 14.3%
  • I’m not shopping for reef deals this year

    Votes: 1 7.1%
  • Other (Post in the comments)

    Votes: 1 7.1%
Back
Top
Home
Post thread…
Market
What's new