Ceramics and High Silicate In Tank

See Gee Sea

Active Member
View Badges
Joined
Feb 10, 2020
Messages
149
Reaction score
94
What state or country do you live in
Massachusetts
Rating - 0%
0   0   0
Hello - I did an ICP test about 5 months ago since I've been battling what looks like diatoms for 18 months now. I can't confirm that without a microscope but it appears on my sand bed and glass in the daytime and dissipates at night. The ICP test showed my silicate level at 515 µg/l. I started running a GFO in a reactor which seemed to help but the phosphate went to near 0PPM and the nitrate went upward of 16PPM and my macro algae in the refugium started to bleach out - naturally. One thing the ICP test mentioned is that ceramics can cause high silicates. I do have the MarinePure ceramic balls in the bed of my refugium. Could this be what's been causing the issues? My RODI water is 0 TDS and the well I draw from has a TDS of 124. Before I buy a silicate test kit, I was just wondering if the ceramic balls could be the culprit.
Current values are Nitrate 12PPM and Phosphate .02.
 
Well water would have a bunch of Si too, and it's pretty hard to remove all of it.
So I'm not sure the ceramic (though possible) is the likeliest source.
 
Upvote 0
I would not assume it is the ceramics, as many either do not contain silicate or do not dissolve.

Testing the RO/DI is a good plan. Silicate can be hard to bind.
 
Upvote 0

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 17.7%
  • Fish or coral food

    Votes: 5 5.2%
  • Test kits or reagents

    Votes: 10 10.4%
  • Filter media or replacement fleece

    Votes: 5 5.2%
  • RO/DI filters or supplies

    Votes: 15 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 12 12.5%
  • I keep a backup of everything

    Votes: 25 26.0%
  • Other (Post in the comments)

    Votes: 7 7.3%
Back
Top
Home
Post thread…
Market
What's new