- Joined
- Jan 31, 2019
- Messages
- 369
- Reaction score
- 166
I'm talking about the connectors that connect their controller to the float switch and motor. They are a plug in connector with an o-ring and threaded nut.
I'd like the get a male and female end (so a set).
I'll then make a fly lead up that I could insert in there (think of it as an extension cord). The purpose would be to grab the status of either the float switch.
I could use this on a digital input of a Profilux. I could set a dosing head to react to the digital input. With an appropriate size "container" and dosing rate I could measure (with a fair degree of accuracy) how much mat had rolled through/how much was left before the roll ran out.
If it all turns pair shaped I won't have cut any of the existing Clarisea cables and the extra piece could be removed.
Thanks
I'd like the get a male and female end (so a set).
I'll then make a fly lead up that I could insert in there (think of it as an extension cord). The purpose would be to grab the status of either the float switch.
I could use this on a digital input of a Profilux. I could set a dosing head to react to the digital input. With an appropriate size "container" and dosing rate I could measure (with a fair degree of accuracy) how much mat had rolled through/how much was left before the roll ran out.
If it all turns pair shaped I won't have cut any of the existing Clarisea cables and the extra piece could be removed.
Thanks