Hi there,
I was directed to this forum from a few users on another forum to in regards to the below question, I also tried contacting Tunze directly from the website, but never got a response;
I have a Tunze regulator with is connected to a solenoid, my question is around the small gauge on the Tunze regulator, manual states that it should be set to 0.5, but I find if it's set it .07 to 1.0bar i get better control over the rate of co2. Is the manual just a rough guide, or should it always bet set to 0.5 bar?
Thanks for any advice or explanation.
I was directed to this forum from a few users on another forum to in regards to the below question, I also tried contacting Tunze directly from the website, but never got a response;
I have a Tunze regulator with is connected to a solenoid, my question is around the small gauge on the Tunze regulator, manual states that it should be set to 0.5, but I find if it's set it .07 to 1.0bar i get better control over the rate of co2. Is the manual just a rough guide, or should it always bet set to 0.5 bar?
Thanks for any advice or explanation.
Last edited: