Conduit Light Hanging Kit - Help with where to bend pipe.

[coralcrazy]

Here is the situation.

Trying to make a 3/4 conduit light hanging bar for my 72" tank. The tank dimension are 72x18x24 tall. I would like to create a bar with two 90 degree bend so I can mount behind the stand.

I am having difficulty figuring out where to make the bend on the 10' conduit pipe.

This is what I am thinking.

First bend 18" from one end (leaving me a 2ft extension).

Second bend 18" from other end (leaving me a 2ft extension).

Third bend 3" from perpendicular bar of one end (creating a 9" extension, center of tank).

Fourth bend 3" from other perpendicular bar end (creating a 9" extension, center of tank).

I will then cut another conduit pipe and couple that with the bar I bent so I can extend where I will attach to stand.

Am I on the right path? Any help would be great. The picture shows the look I am going for, but bends rather then couplets.

 

[Tbone0524]

What kind of conduit are you using and what do you have to bend it with

 

[Tbone0524]

The measurements seem right in line with a EMT bender I would suggest bending the 3" mark first from end of pipe then measure from back of that 90 and mark 18" and bend repeat process for other side

 

[coralcrazy]

I simplified the design at this was the outcome. Just need to paint it.

Shoutout to Dave at Nano Box for making the lights.