COR 20 power supply/brick

  • Thread starter Thread starter Sleepydoc
  • Start date Start date
  • Tagged users Tagged users None

Sleepydoc

Valuable Member
View Badges
Joined
Apr 10, 2017
Messages
1,425
Reaction score
1,251
Location
Minneapolis, MN
What state or country do you live in
Minnesota
Rating - 0%
0   0   0
The power supply for my COR-20 died today while I was doing a water change. I put the pump in standby then noticed a VOLT error when I tried to restart it. After playing around, I noticed that the LED on the power brick wasn't coming on and got 0 Volts when I put a voltmeter on the output.

The power brick says it's 24V 4.2A (=100W). BRS has replacement power brick for the 1Link that's 24V, 5A. Does anyone know if this will this work for the COR 20?
 
The power supply for my COR-20 died today while I was doing a water change. I put the pump in standby then noticed a VOLT error when I tried to restart it. After playing around, I noticed that the LED on the power brick wasn't coming on and got 0 Volts when I put a voltmeter on the output.

The power brick says it's 24V 4.2A (=100W). BRS has replacement power brick for the 1Link that's 24V, 5A. Does anyone know if this will this work for the COR 20?
I just had the same problem. Neptune will replace your power supply for free if your pump is still in warrantee. Otherwise they’ll sell it to you for $50. I would venture to guess though that any 24VDC power supply that can deliver 5+ amps should work with the COR-20 as long as it has the right connector.
 
I just had the same problem. Neptune will replace your power supply for free if your pump is still in warrantee. Otherwise they’ll sell it to you for $50. I would venture to guess though that any 24VDC power supply that can deliver 5+ amps should work with the COR-20 as long as it has the right connector.
Thanks - I got mine almost as soon as they came out, so it's beyond the warranty. Someone on the Neptune forum said the 1Link brick should work so I just ordered one. I'll update here when it arrives...
 
Update:
I took the old power supply apart and determined that one of the switching MOSFET transistors had blown - basically what I expected. I will say that the construction and design of the circuit board seemed to be of good quality.

I received the 1Link power supply from BRS today and it works perfectly. Attached is a picture of the label from both supplies; they're essentially the same.

IMG_0065.jpg
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new