COR15 red light

[joe0813]

Hey guys.... I recently bought a new apex A3 pro to replace my old one that sat in a basement. my cor15 was running fine on the old apex for about 10 days now. switched everything over and now the COR controller is turning red, wont pump water and on fusion says "volt". I have cleaned the pump before I set it back up and tried changing the one link to make sure that wasn't the issue. ill unplug it completely then plug it back in and the problem goes away for a few minutes then randomly acts up again.

 

[joe0813]

Also when it does start to work again the buttons on the CORs little controller dont do anything. It wont increase or decrease power

 

[Vivid Creative Aquatics Verified Sponsor]

Sounds like its not getting power

the aquabus will provide enough power to run the controller, but not enough to run the pump

If you are using a dedicated power supply for the pump, check that. Make sure its plugin in and supplying power. if it is, then possibly it's a bad power supply.

Or, if you are running it off the 1Link Power Connection directly form the EB832 (you can do that with the COR15 pumps, but not the cor20s) make sure you have that outlet set to "ON", otherwise it wont supply power to run the pump.

 

[joe0813]

Sounds like its not getting power

the aquabus will provide enough power to run the controller, but not enough to run the pump

If you are using a dedicated power supply for the pump, check that. Make sure its plugin in and supplying power. if it is, then possibly it's a bad power supply.

Or, if you are running it off the 1Link Power Connection directly form the EB832 (you can do that with the COR15 pumps, but not the cor20s) make sure you have that outlet set to "ON", otherwise it wont supply power to run the pump.

The cor15 can only run off the apex. so unfortunately there is no power supply. Ive swapped two different 1link connectors and still having the same issue. I do have the COR set to on instead of auto too.

 

[Vivid Creative Aquatics Verified Sponsor]

The cor15 can only run off the apex. so unfortunately there is no power supply. Ive swapped two different 1link connectors and still having the same issue. I do have the COR set to on instead of auto too.

Do you have any other devisers you can run off the 1Link concretion like a PMUP, just to verify the 1link is actually working?

 

[joe0813]

Do you have any other devisers you can run off the 1Link concretion like a PMUP, just to verify the 1link is actually working?

Ill try that, didn't think you could connect the PMUP to a cor15 controller

 

[Vivid Creative Aquatics Verified Sponsor]

Ill try that, didn't think you could connect the PMUP to a cor15 controller

Some can - I don't knw if its two different models, but some have the 1link and other have come with a power supply