Current not shown for Switch Channel

[Herbster]

Hi,

Is there any reason why current is not being shown for certain switch channels. I can appreciate if certain items drawn a very small current (like an ATO when not running), but items like my return pump should. Attached is a screenshot of switch channels and the return pump channel.

Is there a setting I should use?

Thanks

 

[Ditto]

I saw you had filter applied to the pump, I assume you were not feeding when you took the screen shot? Otherwise, I can say I never seen this. Did you send a ticket into support?

 

[Lasse]

I have seen it but only when I use the power hubs and have a positive 12 or 24 DC connected to the relay. If I have a 240 V AC phase connected - it will work.

Sincerely Lasse

 

[Herbster]

Thanks for your replies - it is a Powerbar 6E and although the return pump is set as a filter, is is 0 even when not in feed mode. I have raised a ticket with GHl support.

Thanks.