I have never done any acrylic work so I was a bit worried. I found it to be very easy as long as you have the right tools. A good table saw with a long fence for cutting long pieces. A router table, I incorporated mine into the extension I built on my table saw. You must have the skill to make a really straight cut with a table saw, a skill I did not possess at the start of the project but figured it out by the end.
Dimensions are 34 x 15 x 15. Water flows from filter sock chamber- skimmer chamber/reactor chamber- bio media chamber (k1) - refugium - return.
I still have to add heater holders, probe holders, dosing line holders and cord holders but other than that it is complete. Also adding a diy led strip to the lid of the fuge. It will be attached to the lid, stood off the acrylic about 1 inch to keep heat off the acrylic. Very happy with the finished product.
Dimensions are 34 x 15 x 15. Water flows from filter sock chamber- skimmer chamber/reactor chamber- bio media chamber (k1) - refugium - return.
I still have to add heater holders, probe holders, dosing line holders and cord holders but other than that it is complete. Also adding a diy led strip to the lid of the fuge. It will be attached to the lid, stood off the acrylic about 1 inch to keep heat off the acrylic. Very happy with the finished product.