DIY 125 gallon stand build question

[PacoPetty]

This frame was a lot harder to get square than the one I built for my Bio cube 32.

 

[Arricefe]

looks like you are on your way, when i was at this point in my build this is where i decided to build a side box to the frame to install electroincs, and added pvc to the interior

@divermike_99 do you have any post on your stand build? I would love to see more details on it, so I can copy

 

[divermike_99]

@divermike_99 do you have any post on your stand build? I would love to see more details on it, so I can copy

Yeah I’ll try to post more on my stand build are there anything in specific you want to see?

 

[Arricefe]

Yeah I’ll try to post more on my stand build are there anything in specific you want to see?

Is it made from plywood or is it “2x” frame?

 

[Ewok1]

I am building a stand for my 125 gallon long tank. I would like opinions on what to do about the interior base. Should I put two or more cross supports in the bottom topped with plywood or just put plywood in the bottom. I will caulk the entire interior of the stand and seal it with white flex seal. (I would do them the same as the crossmembers on the top but I am trying to add more room inside the stand. Without the crossmembers adds 3 inches)

Maybe make some triangles as they are the strongest support.

 

[divermike_99]

i just kind of went overboard with 2x4's and 3/4" plywood

 

[Apotack]

Drooling over your shop!:)

 

[PacoPetty]

i just kind of went overboard with 2x4's and 3/4" plywood

Overboard is a good thing!