DIY overflow box cover?

  • Thread starter Thread starter Be102
  • Start date Start date
  • Tagged users Tagged users None

Be102

Valuable Member
View Badges
Joined
Nov 29, 2016
Messages
1,884
Reaction score
1,043
What state or country do you live in
Massachusetts
Rating - 0%
0   0   0
So here’s my situation... the big snails like to climb into my overflow box and block the outlet (from display to sump)

I have failsafes for the external part of the box if I got clog in the pipes or whatever and that all works.. except the snail keeps overflowing my display!!

short of hooking some ugly sensors up along mydisplay rim... I figured I’d just sleep easily and make something for the overflow box weir..

I tried to use egg rate but it is not the right size and will not fit. Any other ideas?

5BE93DAB-AB31-4599-9F40-93A6B80EC09B.jpeg
 
If you know anyone with a 3D printer, you can take measurements and have them print you a cover. I did that when I was running my Eshopps PF300
I measured the outside diameter for the cover, and then measured the inside diameter and had him put ridges in it to prevent the cover from sliding around. Measured the diameter of the feed pipe and how far into the overflow it came. Worked great :)
 
If you know anyone with a 3D printer, you can take measurements and have them print you a cover. I did that when I was running my Eshopps PF300
I measured the outside diameter for the cover, and then measured the inside diameter and had him put ridges in it to prevent the cover from sliding around. Measured the diameter of the feed pipe and how far into the overflow it came. Worked great :)
Did you know i was in the 3d printing thread last night .. asking what a good 3d printer was :p this might be the best /easiest and most exciting way to get one done!! (Add 3d printer onto list of things I want lol
 
could put the ugly float switch in the sump. And instead of overfilling measure when underfilled, indicating your overflow is clogged.
 
Easy enough to buy a bit of plastic and cut your own. Just use polycarbonate rather than acrylic as it won’t warp.
 
Easy enough to buy a bit of plastic and cut your own. Just use polycarbonate rather than acrylic as it won’t warp.
Like from Home Depot or
 
I have a home workshop so I use a table saw .... but I recognize that most folks don’t. You can score/snap it or just use a hand saw since you don’t need to do a ton of cuts.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new