DOS Automatic Water Changes and Redundancy?

  • Thread starter Thread starter mstgkillr
  • Start date Start date
  • Tagged users Tagged users None

mstgkillr

Active Member
View Badges
Joined
Aug 11, 2013
Messages
409
Reaction score
157
Rating - 100%
2   0   0
After reviewing the programming procedure for the DOS and automatic water changes, it does not appear to have any redundancy, and simply relies on the accuracy/calibration of the DOS system. What happens if either one of the pumps gets stuck in the on position? I've read of this happening with DOS and two part dosing. I guess you could use constraints from the salinity probe, but I am not sure how accurate it is. I know additional Neptune sensors can be purchased, but can I use the optical sensors already installed with the Neptune ATK? And then maybe add 1-2 more for even more protection?
 
You can use all kinds of different sensors to effect redundancy. I have both high and low floats in my sump that turn off the AWC in the event either is triggered. I have redundant in almost all my equipment.
 
This has always been a concern of mine as well...especially since my second DOS has froze many times, with only ALK dosing and no CA. Like you said, I use the salinity probe and nothing else. I usually try and make sure I am around when the water change starts to make sure both heads are turning.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new