dosing nitrates

  • Thread starter Thread starter beaslbob
  • Start date Start date
  • Tagged users Tagged users None

beaslbob

2500 Club Member
View Badges
Joined
May 11, 2009
Messages
4,086
Reaction score
956
Location
huntsville, al
Rating - 0%
0   0   0
Tomoko

(and others)

just saw this rc thead:

Nitrate addition - Reef Central Online Community

where some are reporting dosing potassium nitrate resulted in better hard corals.

What you think?

I also wonder if it could be a potassium issue as well as plant life does slowly use up potassium. But then we do have a large amount of potassium and it is no used anywhere near as fast as nitrates or phosphates, or calcium carbonate

my .02
 
Sounds like blind leading blind to me at this point. Anecdotal results are not always useful.

Some corals start to pale in an ultra low nutrient tank maintained with a probiotic system. The usual recommendation for that is to feed more or add fish. I don't think we know if it is nitrate, phosphate or another element that causes the anemic look/bleaching. Feeding fish and coral seems to do the trick in most cases, though. It could be nitrate, phosphate or another something we cannot measure. A low level phosphate is so hard to measure that you really don't know if a tank is really phosphate limited when a test kit indicates zero PO4. I hate to jump to conclusion and dose KNO3 for that.

It's quite simple and relatively harmless to test this in a planted FW tank, but with hard corals such as acropora, you run the risk of browning them up.

When I noticed a strange anemic look among my sensitive acroporas a few years ago (I was dosing vodka for over 9 months at that point), I suspected that it may be some sort of nutrient limitation. However, it turned out that my RO membrane was damaged by excess chlorine that the city of Madison used after a break in the water line. As you know, I do biweekly water changes. I kept checking for this and that, but I never suspected that a relatively new RO membrane was shot so quickly. When I finally tested my RODI water (after two or three more water changes :shame:), I knew immediately what was making some of my corals so unhappy. TDS was reading 94 ppm after DI :oh: No wonder.

This statement by Seachem that they sited, "no free ammonia is released because the ammonium in Flourish Nitrogen™ is complexed and unavailable until utilized by the plants", is also a concern for a reef trank. This is fine with FW planted tank where pH is maintained normally from 6.6 to 6.8. When the pH goes up to sea water level around 8, the complexed ammonium will take the form of ammonia which is really bad for our livestock.
 
Last edited:

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new