Double check my Lanthanum Chloride calcs

LobsterOfJustice

Valuable Member
View Badges
Joined
Dec 3, 2013
Messages
1,462
Reaction score
1,480
Location
Cary, NC
Rating - 100%
2   0   0
Just picked up some Brightwell Phosphat-E, from all reports and descriptions this is lanthanum chloride but they don’t say so directly on the bottle.

The instructions state 1 mL removes 1 ppm from 4 gal. By my calcs, this means 1 mL would remove 0.015 ppm from 270g. This seems like a reasonably conservative amount of phosphate to remove in a given dose and is easy to measure and remember. Just wanted someone to confirm because I don’t want to change my levels too fast. I plan to mix with about a gallon of RODI water and drip into mechanical filtration.
 
If you'd like to be conservative, dose 1/2 gallon one day, then the other half a few days later. My simpleton math agrees with yours, but keep an eye on alkalinity since the reaction will use a little bit.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new