Double Junc. Ph Probes and APEX

[Salty1962]

I saw a while back that APEX was having trouble recognizing double junction Ph probes. Does anyone know if this has been rectified?
Thx

 

[jsker]

?? a little more back ground please:)

 

[Salty1962]

I saw a post where @"Sabellafella" had posted an issue with getting the APEX to read the double junc. Ph properly. And I believe some other people had mentioned it elsewhere. I didn't know if APEX found an issue and if it's been corrected?

 

[Terence]

There is no issue with double junction probes. All Apex Systems (2016) now ship with DJ DJ will often take a bit longer to adjust (two junctions after all) to changes but this is a matter of seconds and not an issue in our application where ph values do not change rapidly.

 

[jml1149]

I saw a while back that APEX was having trouble recognizing double junction Ph probes. Does anyone know if this has been rectified?
Thx

The electrical signal from a single junction probe is exactly the same as a double junction probe, which is why they're 100% interchangeable. This wouldn't be an issue for ANY device reading the probes, not just Apex.

 

[jsker]

I saw a post where @"Sabellafella" had posted an issue with getting the APEX to read the double junc. Ph properly. And I believe some other people had mentioned it elsewhere. I didn't know if APEX found an issue and if it's been corrected?

Got it, when I replace my probe this spring I went with the double junction with issue.

 

[Salty1962]

?