Drilled 1st tank, but....

  • Thread starter Thread starter cobray
  • Start date Start date
  • Tagged users Tagged users None

cobray

Community Member
View Badges
Joined
Aug 20, 2023
Messages
39
Reaction score
14
Location
Brownstown
What state or country do you live in
Michigan
Rating - 0%
0   0   0
So I think my first attempt was a success, but on the 2nd hole, the drill bucked and chipped the outer face of the glass.
Wondering if it will eventually crack.
Please see attached pics.
Thanks!
20230904_093220.jpg
20230904_093214.jpg
20230904_093133.jpg
 
I would silicone that chip and water test the bulkheads. You should also sand the hole and clean up the inside a bit. It looks like you didn't finish the hole.
 
Sounds good. Thanks for the replies.
I'll clean it up and silicone the bulkhead both sides.
 
That was my thought. As long as the bulkhead seal covers it you will probably get away with that. You could try filling that with epoxy, but if you can’t get the seal surface flat you may make it worse.
For reference I’ve had professional made tanks with little chips in the edge of the hole before, albeit smaller than that. But like I said, if you can get a seal you’ll be ok.
 

TOP 10 Trending Threads

HOW WOULD YOU FEEL ABOUT RECEIVING A FISH OR CORAL AS A HOLIDAY GIFT?

  • I’d love one, as long as it’s a species I chose

    Votes: 26 24.5%
  • I’d trust someone who knows my tank to choose

    Votes: 9 8.5%
  • I’d rather get a gift card and pick it myself

    Votes: 43 40.6%
  • I’d prefer gear or supplies instead

    Votes: 2 1.9%
  • Please don’t surprise me with livestock

    Votes: 26 24.5%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new