moreef
Well-Known Member
I just did the qd driver upgrade to one of my mp40 and cant get it to connect with fusion/wxm.
I have the wxm module and have been controlling it fine within fusion but now it says missing after the driver upgrade. I get the yellow/blue light that indicates it is attached but on fusion I have the red missing.
The pump is working I just cant control it in fusion. One thing that I did notice is the chip that they have you remove from old driver and put in new was backwards on the directions. Could this be the issue?
I did the other mp40 a year or so ago and remember it was also a pain to reattach. Thanks, Eric
I have the wxm module and have been controlling it fine within fusion but now it says missing after the driver upgrade. I get the yellow/blue light that indicates it is attached but on fusion I have the red missing.
The pump is working I just cant control it in fusion. One thing that I did notice is the chip that they have you remove from old driver and put in new was backwards on the directions. Could this be the issue?
I did the other mp40 a year or so ago and remember it was also a pain to reattach. Thanks, Eric
