Finnex HC-810m Controller and 500Watt Heater

Status
Not open for further replies.
This thread is for the general discussion of the classified ad Finnex HC-810m Controller and 500Watt Heater. For more information about this item, please click the link or ask a question in this thread.

Please add to the discussion here.
I am setting up a new Finnex HC-810M controller with an Finnex 800 W heater. Once hooked up it did not allow setting of the temp limits. It just had a continuous alarm. The sensor & heater are in the sump. Is it defective? It’s supposed to be a pretty simple set up. Thanks
 
I am installing a new Finnex HC-810M controller with a Finnex 800 w heater. There is a continuous alarm when plugged in and it does not allow setting temp limits. The alarm will not shut off. The sensor and heater are in the sump. Thanks,
Randy
 
Status
Not open for further replies.

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new