Floating reef aquascape

So got rid of sand bc it was causing issues w/nitrates and phosphates. I was out of town too and someone overfed the tank. :-( lost my clam and some acros. Added a UV sterilizer which cleared up the water. Also added a heater. Its heading in the right direction now. I need to glue the zoas to the rock and figure out where to put the holly grail torch. Im dosing reef fuel (carbon source) and keeping Alk at 7. Havent measured in a few weeks though. I have more problems when I run higher Alk.
I agree, I think o may remove my sand also, same problems with high alk but I use reef crystals and it runs high on alk,but I can't justify spending more on another salt mix. I've heard of dosing calcium chloride to lower alk,but it'll adjust other levels.
 
yep...I building a 300 and have 20 pounds of sand only in far back corner for the wrasses...otherwise its bare bottom...
 
PXL_20220320_215004695.jpg
 

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 8 36.4%
  • Powerheads or wavemakers

    Votes: 2 9.1%
  • Sump or rear filtration chambers

    Votes: 2 9.1%
  • Skimmer or other filtration equipment

    Votes: 1 4.5%
  • Overflow or plumbing

    Votes: 6 27.3%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 2 9.1%
  • Other—tell us what I missed

    Votes: 1 4.5%
Back
Top
Home
Post thread…
Market
What's new