Frag plugs

  • Thread starter Thread starter B-ridge
  • Start date Start date
  • Tagged users Tagged users None

B-ridge

Valuable Member
View Badges
Joined
Nov 27, 2014
Messages
1,280
Reaction score
469
Location
Upstate New York
Rating - 0%
0   0   0
whats the easiest and safest way to take corals off of a frag plug without “injuring” the coral. The larger wooden ones seem to be easy. The stem pops right off. The smaller wooden ones are not as easy. Then the plastic colored ones seem to be even worse. Any tips or suggestions?
 
I have a pair of side cutters/ wire cutters that I grab firmly at the base and pop it off. I use wire cutters because it has less surface area than needle nose or regular pliers.
 
If the coral hasn't started to encrust the plug u can use a thin tipped flat screwdriver and get under the epoxy and pop it off, if it's an sps that has started to encrust the plug then all u can do is cut the coral off.
 
I use my fragging tools to get under the plug
 
Ok. I’m thinking of using something like a dremel and just cut the stem off the plug. Or like what was said upwards I can get a razor blade and cut the coral off the plug as long as it’s not encrusting
 
Ok. I’m thinking of using something like a dremel and just cut the stem off the plug. Or like what was said upwards I can get a razor blade and cut the coral off the plug as long as it’s not encrusting
Large wire cutters will cut the stems off the plugs easily.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new