GCC Fill Water Options

[blfuller123]

I currently use Fill Water as a function for my auto top off pump that is mounted in my stand. I have it set with a delay turn on and I have it set to run for up to 2 minutes and this works well for me.

I am adding a power bar next to my mixing station in another room and plan on moving this ATO pump there. I was configuring the new ATO socket on and planned on using the same functions that it was already when I noticed in GCC that there are 3 different fill water functions. I know one is for ATO and one is for AWC and the third just says Fill water. I have been using the one listed as Fill water but was wondering what are the differences between functions Fill water, Fill water (ATO Only), and Fill water (AWC Only)?

 

[Ditto]

@Vinny@GHLUSA

Maybe a support ticket on it also?

 

[AZMSGT]

Good darn questions.

 

[Vinny@GHLUSA]

Fill water - For general ATO, Leak Detection, Return pump function purposes
Fill water (ATO only) - For general ATO purposes or when AWC & ATO function is used.
Fill water (AWC only) - For water change purposes.

 

[blfuller123]

Fill water - For general ATO, Leak Detection, Return pump function purposes
Fill water (ATO only) - For general ATO purposes or when AWC & ATO function is used.
Fill water (AWC only) - For water change purposes.

So do the function differently or do they just have different names?

 

[Vinny@GHLUSA]

Yes, they function differently because they are used for specific circumstances as mentioned earlier.

 

[blfuller123]

Yes, they function differently because they are used for specific circumstances as mentioned earlier.

Ok...I guess my question is how do they function differently?

 

[ingchr1]

Ok...I guess my question is how do they function differently?

Does the descriptions in the Programming and Resource Guides help any?