GFO reactor question

  • Thread starter Thread starter cotofl02
  • Start date Start date
  • Tagged users Tagged users None

cotofl02

Active Member
View Badges
Joined
Aug 18, 2021
Messages
487
Reaction score
334
Location
jacksonville
What state or country do you live in
Florida
Rating - 0%
0   0   0
Hello All. I just installed a reactor on my XL 300. I had my phosphates pegged at around .08-.1 for a long time. About a month ago I tried some reef roids and they shot up to around .5 between my weekly tests. I took a break from from all coral foods with the hope that the phosphate would drop. Unfortunately they kind of leveled out around .35. I setup my reactor with 1/3 high capacity GFO and 2/3 Rox carbon. I ran this for 6 hours yesterday and when I tested this morning it dropped to .09. I have a controller and can schedule times for the reactor, has anyone used this approach to slow the effects of GFO or am I better off letting it run 24/7 and lowering the flow through the reactor? Any feedback is greatly appreciated.

1 year old tank
temp - 78
nitrate - 13PPM
phosphate - .09PPM
dKH - 8.5
Ca - 420
Mg - 1400
 
Less gfo would be my first approach. If I already added too much then less flow would be my second.
 
Hello All. I just installed a reactor on my XL 300. I had my phosphates pegged at around .08-.1 for a long time. About a month ago I tried some reef roids and they shot up to around .5 between my weekly tests. I took a break from from all coral foods with the hope that the phosphate would drop. Unfortunately they kind of leveled out around .35. I setup my reactor with 1/3 high capacity GFO and 2/3 Rox carbon. I ran this for 6 hours yesterday and when I tested this morning it dropped to .09. I have a controller and can schedule times for the reactor, has anyone used this approach to slow the effects of GFO or am I better off letting it run 24/7 and lowering the flow through the reactor? Any feedback is greatly appreciated.

1 year old tank
temp - 78
nitrate - 13PPM
phosphate - .09PPM
dKH - 8.5
Ca - 420
Mg - 1400
Not a good idea to trap water inside a device because it becomes anaerobic, though short time periods mightnot be an issue. Better to use less GFO or decrease the flow.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new