ghl leakage sensors not showing

[leedsrhinojohn]

I have connected my leakage interface and 2 leak sensors but where do I find them on the control centre?

 

[Hitman]

@Lasse may be able to help you on this one.

 

[JoshH]

I can't be much help but I'll tag a few more in here @Ditto @Vinny@GHLUSA @Matthias Gross

 

[reefwiser]

 

[Lasse]

It works a little as a level indicator. You connect the interface them to one level contact. After this you have to identify which sensor it will use. Go to level - sensor and state sensor level

​

Notice each sensor state a + or a - Now put the sensor in contact with saltwater - in a way as a leak will do. The sensor that change its state is the actual one. Now open Settings.

​

Operation mode leakage detection put the identified sensor number into "used sensor for control" I would set maximum on time to 0.00.0 because i think you will have the alarm direct in that case.

Sincerely Lasse

 

[Lasse]

I was late :) The video is better than my explanation :)

Sincerely Lasse

 

[leedsrhinojohn]

Thanks guys