Hammer recession?

sheeb

Active Member
View Badges
Joined
Mar 16, 2022
Messages
482
Reaction score
240
Location
usa
Rating - 0%
0   0   0
0B782354-E448-4F54-A3C9-3DC1BCF7B116.jpeg

Took this pic while lights are turning on, is the white tissue recession?
 

Mastiffsrule

Where ever you go, there you are, so be nice 2 you
View Badges
Joined
Feb 10, 2019
Messages
8,440
Reaction score
33,571
Location
Charlotte
Rating - 0%
0   0   0
Looks ok, you want to look out for any visible skeleton or polyp bail-out.
 

vetteguy53081

Well known Member and monster tank lover
View Badges
Joined
Aug 11, 2013
Messages
90,861
Reaction score
200,137
Location
Wisconsin -
Rating - 100%
13   0   0
Its slight recession due to stress. Main stressoe is water flow followed by light then calcium. Hammer requires Stable tank conditions, and is intolerant to major swings in water quality, and is sensitive to almost any level of copper in the water. Since they are a large polyp stony coral, calcium and alkalinity are two very important water parameters that will affect the growth of your coral. This coral will start to die off if the calcium levels are too low. A calcium level of about 400 ppm is just right.
This coral species isn’t terribly picky when it comes to the proper placement in your tank. The trick would really be just to avoid the extremes. Avoid extremely bright locations or areas of very high current, and avoid areas that are too dark or with currents that are too low. Fast currents risk damaging the soft, fleshy polyps (and getting an infection). Bright lights will cause bleaching. Insufficient lighting will cause the poor coral to wither away and starve to death.
Hammer corals only require a moderate amount of light for photosynthesis and can grow well in the intermediate regions of your tank. Just about any reef LED lighting should be sufficient for most tanks. Reduce white light intensity and get it off the sand bed which sand can irritate it.
The polyps should sway in the current, but not sustain so much pressure they are constantly bent over their skeleton. Too much flow will tear the polyps (worst case) and cause the polyps do not extend in the first place (best case). So, don’t give them too much flow.
 
OP
OP
S

sheeb

Active Member
View Badges
Joined
Mar 16, 2022
Messages
482
Reaction score
240
Location
usa
Rating - 0%
0   0   0
Could be new growth. Is it fully expanded when lights are full.
Yes. Looks happy thruout the day but I’m selling it and buyer was a bit worried about recession, which I totally understand. Wouldn’t want a dying piece of coral
 
OP
OP
S

sheeb

Active Member
View Badges
Joined
Mar 16, 2022
Messages
482
Reaction score
240
Location
usa
Rating - 0%
0   0   0
Its slight recession due to stress. Main stressoe is water flow followed by light then calcium. Hammer requires Stable tank conditions, and is intolerant to major swings in water quality, and is sensitive to almost any level of copper in the water. Since they are a large polyp stony coral, calcium and alkalinity are two very important water parameters that will affect the growth of your coral. This coral will start to die off if the calcium levels are too low. A calcium level of about 400 ppm is just right.
This coral species isn’t terribly picky when it comes to the proper placement in your tank. The trick would really be just to avoid the extremes. Avoid extremely bright locations or areas of very high current, and avoid areas that are too dark or with currents that are too low. Fast currents risk damaging the soft, fleshy polyps (and getting an infection). Bright lights will cause bleaching. Insufficient lighting will cause the poor coral to wither away and starve to death.
Hammer corals only require a moderate amount of light for photosynthesis and can grow well in the intermediate regions of your tank. Just about any reef LED lighting should be sufficient for most tanks. Reduce white light intensity and get it off the sand bed which sand can irritate it.
The polyps should sway in the current, but not sustain so much pressure they are constantly bent over their skeleton. Too much flow will tear the polyps (worst case) and cause the polyps do not extend in the first place (best case). So, don’t give them too much flow.
In the lowest flow area of tank but not no flow. Calcium levels are a bit low last I checked but I couldn’t see why it would be stressed. In great water, bit of flow, and getting good light. Will check on it tomorrow
 
Back
Top