Hanna Marine Nitrate Test Filter Leak Solved

  • Thread starter Thread starter Dan_P
  • Start date Start date
  • Tagged users Tagged users None

Dan_P

10K Club member
View Badges
Joined
Sep 21, 2018
Messages
10,230
Reaction score
10,179
Rating - 0%
0   0   0
I just started using the Hanna Marine Nitrate Checker and liked every step of the procedure except one: filtration. No matter what I did, nothing stopped the occasional, seemingly random leaking. The “autopsy” I performed after each leaky filtration provided me with no insight into the leak. So, this morning after dealing with another leak, I decided to take a closer look at the filter which is beautifully made but failing all the same.

The filter is sealed when the top cover containing the silicon gasket is screwed down, pressing the soft gasket over the raised lip that forms the outer edge of the seat for the filter disk. Simple. It should work, but I saw imperfections on this raised edge that could conceivably allow liquid to squeeze under the gasket and follow the channel created by the less than smooth surface. I used 800 grit emory cloth and a circular motion to slowly sand down the sharp edge to a wider flat surface. After several sanding and pressure testing cycles, the seal was perfect. I made the seal so good that in my last pressure test of the syringe, I managed to blow off the top of the filter without any leaks prior to the catastrophic failure. Luckily, the filter was not ruined.
 
I find that the zinc leaves some accumulating grit behind in the plastic surface inside of the filter holder. I assume that this could be dissolved with acid, but haven't tried yet.
 
Good catch on the rough edge! My favorite mess is when one the the gridded inserts gets put in upside down after cleaning, and the filtered water is as gray as the unfiltered water :rolleyes:;Facepalm
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 17.7%
  • Fish or coral food

    Votes: 5 5.2%
  • Test kits or reagents

    Votes: 10 10.4%
  • Filter media or replacement fleece

    Votes: 5 5.2%
  • RO/DI filters or supplies

    Votes: 15 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 12 12.5%
  • I keep a backup of everything

    Votes: 25 26.0%
  • Other (Post in the comments)

    Votes: 7 7.3%
Back
Top
Home
Post thread…
Market
What's new