- Joined
- Dec 31, 2015
- Messages
- 513
- Reaction score
- 172
I could use some help adding redundancy and safety to my auto-water change via my apex. I have an FMM x2, EB4, and a dos in my garage that has Rodi run to my tank that has an ATK, FMM, and a leak sensor under the stand. My saltwater bin has a high and low water sensor in the bin.
I have the apex setup to change over 1.5 gal daily. I was doing manual changes with the dos and it had a built in stop for the low water sensor and for a sensor for the waste bin being full which I set to the leak sensor and duplicated it to the high water sensor on the ATK
I can’t figure out how to do this with the automatic changes. Can someone help me out or give me some better ideas on how to make this safer?
Thanks!
I have the apex setup to change over 1.5 gal daily. I was doing manual changes with the dos and it had a built in stop for the low water sensor and for a sensor for the waste bin being full which I set to the leak sensor and duplicated it to the high water sensor on the ATK
I can’t figure out how to do this with the automatic changes. Can someone help me out or give me some better ideas on how to make this safer?
Thanks!