Help with computer drawing???

[Mstanker]

Is there anyone out there that will help me with draw some computer drawings for me. If so would you PM me and i will tell you my design with the two tanks. Thanks for any help.

 

[dacianb]

If you are not in big hurry i can help. but cannot spend too much time daily.

 

[Mstanker]

Thats fine, i already have a 40g breeder reef. I want to get my 75g tank started up also. Here's what i was thinking of building a steel stand out of square tubing. Putting the 75g tank on top and the 40GB to the left or right side of it ''UNDER THE 70G''. Also i have a trigger system sump already on the 40g. So it would be the 75g on top, 40g second, then the sump. Trying to figure out the measurement and if i would work out.

Everything is going under the 75g tanks

 

[beaslbob]

first rough draft sketch so you can tell me how wrong the sizes are and locations.

 

[beaslbob]

ahhh drat
the 40g breeder should be 36 3/16 wide not 34.
and 16.9375 (15/16) front to back.

 

[Mstanker]

Nice, Is there a way i can see like what it would be like if i had to build a stand for it. What does the original stand H have to be for the 75g for the 40gb to fit under it with enough room for lighting. and then with the sump eiither to the side or the 40gb or off set under it?

 

[dacianb]

Did you tried Google Sketch ?? You can have nice 3D drawings with it; For me is a bit hard to help - I am in Belgium, we use mm :nerd:

 

[Mstanker]

No i didnt know there were free programs like that