Help with dos code

[MMI]

Hello all,

My RODI reservoir is in my basement and my top off reservoir is located on the first floor on the opposite side of the house. I'm trying to use a DOS to auto refill the top off reservoir as a pmup from the basement is too slow and can't keep up with my evaporation.

I created a DOS profile called ro2tordose and set the speed to 250ml/min. I then went into the dos and put in the below programming. When there is nothing other than "set ro2tordose" the dos runs at max speed. However, as soon as I add in any other line of code, it runs at a much slower speed and can't keep up with my evaporation.

How can I speed up the dos but also make sure I don't end up with a flood in my living room?

 

[Tangdora]

“Then On” is not the same as using “then ro2tordose“ when you want to activate the profile. “Then on” would activate what you have set up in the table not profile itself.

 

[MMI]

“Then On” is not the same as using “then ro2tordose“ when you want to activate the profile. “Then on” would activate what you have set up in the table not profile itself.

Thanks so much!

 

[Tangdora]

As an fyi. When the outlet is set to auto and a profile is properly called. You will see the outlet status as the name of the profile itself and not just showing ON