How do you change settings on an MP10?

timrocks311

Active Member
View Badges
Joined
Apr 20, 2017
Messages
439
Reaction score
342
Location
West Grove, PA
What state or country do you live in
Pennsylvania
Rating - 0%
0   0   0
Ok, this sounds like a stupid question but everytime I try to change settings on my MP10 it doesn't save it. I have two MP10s linked. They run in gyre mode alternating. I want to increase the speed a bit. If I hit set, turn it up, set, confirm the time, then set again, it doesn't change. It just stays with the same settings it's been at. What's the trick with these things? Thanks.
 
Ok, this sounds like a stupid question but everytime I try to change settings on my MP10 it doesn't save it. I have two MP10s linked. They run in gyre mode alternating. I want to increase the speed a bit. If I hit set, turn it up, set, confirm the time, then set again, it doesn't change. It just stays with the same settings it's been at. What's the trick with these things? Thanks.

You may want to try to reset up the pumps including clearing the memory. Here is a link to EcoTech's MP10 instructions on Setting Up a Master Slave Relationship 2 Pump Configuration. Good luck!
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new